Thermostats | Speed
Controls | Humidistats | Timers
control lets you adjust the fan speed for exhaust and circulation fans in your
greenhouse from 20% to 100% of output capacity (Minimum output depends on fan).
It also has the ability to turn a fan on and off. Controller comes in weather
proof electrical enclosures with watertight cover. This controller is very helpful
in the winter when less ventilation is necessary and too much cold air flow at
once from outside can cause temperature shock to nearby plants. Only use with
fans approved for variable speed operation (includes all 20" and smaller
ACF variable speed exhaust and circulation
fans). Operates on 110/120 voltage up to 5 amps.
Prewired Fan Speed
This is the same as the ACF variable fan speed control above except it comes prewired
with an 8' grounded power cord with outlet. Simply plug the speed control into
a standard 110/120 volt outlet. Then plug any 110/120 volt appliance into the
outlet on the plug of the speed control. Only use with fans that have plugs and
are approved for variable speed operation like the ACF
variable speed exhaust and circulation fans.
Amp Fan Speed Control
This variable control lets you adjust the fan speed for fans in your greenhouse
from 20% to 100% of output capacity (Minimum output depends on fan). It also has
the ability to turn a fan on and off. Controller comes in a weather proof electrical
enclosure suited for greenhouse environments. Great option for equipment requiring
a controller that can handle higher amperages like the ACF
24" variable speed exhaust fan. Operates on 110/120 voltage up to 10
| This control
is used to turn on a humidifying device like a solenoid
valve which powers a misting system when the humidity level drops below the
level you select (20% - 80% range). It then turns the device off after the humidity
rises back to the percentage selected. No wiring is necessary. Simply plug the
device you want to control into the outlet on the plug of the humidistat, and
select the percentage of humidity you want to maintain. Comes with 8' power cord
with outlet. Operates on 110/120 voltage up to 6.5 amps.
EOS1 Humidity Controller
| The EOS1
controller is both a humidistat and a dehumidistat. It can be changed from humidify
to dehumidify and back with the flip of a switch. In Humidify mode, it
can be used to turn on a device like a solenoid valve
which powers a misting system when the humidity level drops below the level you
select. In Dehumidify mode, the controller can turn on a circulation
fan, exhaust fan, or dehumidifier when the humidity
level rises above the selected level. No wiring is necessary. Simply plug the
device you want to control into the outlet on the plug of the EOS1 controller,
and select the percentage of humidity you want to maintain. Comes with 6' power
cord. 10% - 90% humidity range. 4% differential. Operates on 110/120 voltage up
to 15 amps.
Repeat Cycle Timer
| This cycle
timer is capable of accurately cycling equipment in increments from 1 second to
40 minutes of "ON" time and 1 minute to 8 hours of "OFF" time
between cycles. Timer has a built-in photosensor that cuts the timer off when
it gets dark. Photosensor may be switched on or off as desired. It is ideally
suited for irrigation, misting, drip, and ventilation controls to name a few.
Solenoid valve is needed to automate most misting,
drip, and irrigation systems.
Timer plugs into a standard 110/120 volt outlet and has an outlet on the front
for the device it will control (15 amp max)
Repeat Cycle Timer with Photosensor
| This timer
is designed to control devices that must be activated on a repeating cycle.Solenoid
valve is needed to automate most misting, drip,
and irrigation systems. It offers an extremely wide range
of time delays, and can be set in hours, minutes and seconds. Its entirely digital
design makes it extremely precise, and its intuitive user interface make it easy
to set up and use. It has two receptacles on the unit that can control up to 15-amps
of power. Timer also has a photsensor which allows you to run it during the day,
night, or both.
Minimum time setting: 10 seconds
Maximum time setting: 24 Hours
Day Programmable Digital Timer
| This digital
timer operates off of an internal clock and can be programmed with up to 8 different
on & off settings per day. Each setting can be set to occur daily or during
specific days of the week. Each on or off period is programmed in 1 minute increments.
Timer features a heavy duty grounded outlet on the front and plugs into a standard
110/120 volt outlet (15 amp max).
Heating | Venting
| Misting | Lights | Controls
| Benches | Meters
Watering | Electrical
| Plastic | PVC | Books
| Containers | Other
380 Greenhouse Drive
Buffalo Junction, VA 24529
434-374-2706 Phone, 434-374-2055 Fax
888-888-9050 Toll Free
Copyright Aarons Creek Farms, Inc. All Rights Reserved.